Program change commands

Hi Folks!

does anyone of you manage to make the mono (mk1, v2.0) receive program change messages from a DAW? It feels like I have tried everything, but no success. I use renoise as DAW, but I think it does not matter, since another device receives PC commands just fine if set to the same channel.

The mono receives notes and start/stop, but does not change the pattern/patch when a program change command is sent. is there a setting that I am missing?

any advice would be appreciated!

It turns out that updating to firmware 2.1.0 solves the issue! it works very well now :slight_smile:

1 Like