Today, I went to turn on my MK2 and its not working at all and the LEDs just flash on and off periodically. Has anyone else had this issue?
I held down the “Pattern” and “Run” buttons down during boot up just like the instructions from the latest firmware update and it booted up and works normally. However, if I shut it off for a few hours it reverts back to flashing LEDs and no longer works. If I try the Pattern and Run boot up sequence again it starts functioning again.
This is incredibly frustrating and because of this boot up issue I believe it’s some kind of firmware/software issue. I absolutely love this synthesizer but man this is incredibly disappointing. I reached out to Norand for help and haven’t received any response.
Sometime this weekend I’m going to try and post a video of the issue.